Cold-formed members are often more difcult todesign than conventional hot-rolled members because oftheir thinness and the unusual shapes that can be roll-formed. All Rights Reserved.Neither this book nor any part may be reproduced or transmitted in any form orby any means, electronic or mechanical, including photocopying, microlming,and recording, or by any information storage and retrieval system, withoutpermission in writing from the publisher.Current printing (last digit):10 9 8 7 6 5 4 3 2 1PRINTED IN THE UNITED STATES OFAMERICAPrefaceThis book describes the structural behavior and design ofcold-formed steel structural members, connections, andsystems. They are often referenced in industry acceptance criteria, and lead the way in establishing the performance characteristics of unique products and applications.ISBN: 0-8247-9294-7This book is printed on acid-free paper.HeadquartersMarcel Dekker, Inc.270 Madison Avenue, New York, NY 10016tel: 21 fax: 21Eastern Hemisphere DistributionMarcel Dekker AGHutgasse 4, Postfach 812, CH-4001 Basel, Switzerlandtel: 41-6 fax: 41-6World Wide Webhttp:aapublisher offers discounts on this book when ordered in bulk quantities.For more information, write to Special SalesaProfessional Marketing at theheadquarters address above.Copyright # 2001 by Marcel Dekker, Inc. It also permits manufacturers to determine limiting height values for the assemblies.ĪISI test standards are updated every five years and facilitate research and development leading to improved state-of-the-art solutions in steel for the construction market.
This standard provides an alternative to the calculation of capacity based on AISI S100, North American Specification for the Design of Cold-Formed Steel Structural Members. In addition to theĬold-formed steel framing, gypsum board panels are considered part of the wall assembly. This standard applies to bridging connectors attached to a cold-formed steel wall stud and the bridging member by mechanical fastening.ĪISI S916-15, Test Standard for Cold-Formed Steel Framing – Nonstructural Interior Partition Walls With Gypsum Board, 2015 Edition – AISI S916 is a new test standard that establishes a rational method of determining the strength and stiffness of nonstructural interior partition wall assemblies framed with cold-formed steel. In this edition, changes are made to allow the 1/8-inch deflection limit to exclude the initial deflection up to 10 percent of the ultimate load for gravity loading only.ĪISI S915-15, Test Standard for Through-the-Web Punchout Cold-Formed Steel Wall Stud Bridging Connectors, 2015 Edition – AISI S915 is a new test standard that provides the methodology to determine the strength and deformation behavior of through-the-web punchout bridging connectors for cold-formed steel wall stud bracing for nonstructural and structural wall studs in light-frame construction.
#Aisi cold formed steel framing shapes free#
All test standards have been approved by the American National Standards Institute (ANSI) and are available for downloading free of charge at The test standards include:ĪISI S914-15, Test Standard for Joist Connectors Attached to Cold-Formed Steel Structural Framing, 2015 Edition – This standard, which replaces AISI S914-13, provides a method for determining the strength and deformation behavior of joist connectors used in cold-formed steel light-frame construction. The American Iron and Steel Institute (AISI) has published three test standards in its S900-series.
0 kommentar(er)
